Full Radio
To complete the Lab we were required to construct a complete radio that could pick up a signal with our antenna and then interpret the signal and play it for us to hear. For my final radio, I was able to choose which components I would like to use. I based my decision on the performance of each component in the lab as well as its simplicity. I wanted my radio to be as simple and effective as possible.
Antenna
The antenna was the only piece of the radio that we were unable to choose between multiple configurations. However, we were given some leeway on the design of the antenna. We were suggested to use a pizza box and wrap the wires around it then tune it with a trimming capacitor. My partner and I used a large pizza box and were able to fit 10 turns around it.
RF Amp
The RF amplifier was a two stage amplifier. The first stage was a common source amplifier. I decided to use this Amp because it was very easy to construct and provide sufficient gain of the input AM waveform. The second stage of the amp was a common emitter amp. The purpose of the second stage is to increase the overall gain of the RF amp and I chose the CE because it provided strong gain and worked well in conjunction with eh CS amp.
Detector
The detector was an important stage to the radio and could have a serious impact on the radios quality of output. For this component, I chose to find the design that worked the most efficiently which was the simple biased diode. This detector accurately matched the amplitude of the input AM waveform.
Audio Amp
The final component that I was able to chose was the Audio amp. I had the most number of options for this component, so I had difficulty choosing the right combination for the two stage amp. I found that the best gain I received was from the OP amp which used a simple integrated circuit. I tried that amp with the multiple buffer amps that I had available and determined the best combination to be with the AB push pull.
At the end of the semester, my final AM radio consisted of 4 components: the antenna, the RF amp made of CS and CE amps, the detector made of a simple biased diode detector, and the Audio amp made of an OP and AB amps. Below is a video of my working radio picking up the Paul Finebaum show.