Lab 6
Antennas
Lab 6 introduced us into the final piece of our radios, the antenna. We constructed a square loop antenna because it is easily tuned for specific stations. Since there are only two AM stations in Auburn it was logical for us to construct a loop antenna and then tune it for the two stations. We created our antenna using a large pizza box from Dominos and wrapped wire around the box to create multiple loops around the box.


We constructed our antenna using the pizza box and quickly began trying to tune it. However, we had very little success in acquiring a usable signal. The best we were able to achieve was to reduce the noise of the signal received by the antenna. We were able to locate the peak of our antenna using the spectrum analyzer and found it to be -91.9dBm at 1230kHz. That resulted in a voltage amplitude of about 8e-6 V. By the end of the lab our antenna did not perform at the necessary level to pick up the desired signals. The poor signal detection is likely due to our poor tuning of the antenna. To improve the antenna before the final project is due we intend to continue to tune it in our lab time so that we can pick up the necessary frequencies.
Conclusion
Lab six gave us the final piece needed to finish our radio, however the antenna was the most difficult piece to get working. Unlike the previous components, the antenna was not simply built and ready to go. The antenna needed tuning which required a different style of debugging than all the previous components since we could not see the problem. The antenna proposed a unique challenge as well because it required a strong understanding of the spectrum analyzer and its data to properly tune the antenna. Since completing this lab, I have began to cover antennas in my electromagnetism class and I believe that the information that I have learned about antennas will equip me to improve my groups antenna. While most of our learning has been focused on the communication between the antennas not the construction, I believe that I now have a better grasp on the fundamentals of antennas so that I can more easily understand what I am trying to accomplish with this antenna.